Speaker Frequency Test
Play standard sine waves at low, mid and high to judge three-band balance and distortion.
Frequency response test
Play standard sine waves at low, mid and high frequencies, plus a custom frequency.
Frequency
Test tips
- Make sure the audio output device is connected and selected.
- Headphones are best for judging channel separation.
- Keep the system volume moderate (around 30%) before starting.
- Lower the volume before loud tests to protect your hearing.
Frequency response in detail
Frequency response describes how loud each band is. Listening to low (100Hz), mid (1kHz) and high (8kHz) in turn quickly reveals whether the three bands are balanced.
Reference points:
Low 100Hz: the bass foundation — checks depth and that bloated feel; overly loud points to a bass-heavy tune.
Mid 1kHz: the core of the human voice — checks mids are full and clear.
High 8kHz: treble detail — a dull or piercing high end both signal a problem.
Custom frequency: enter anything from 20–20000Hz to probe the response curve point by point.
Listening tips:
Lower the volume before testing high frequencies — they hit the ears hard.
Close your eyes and compare band loudness to spot obvious peaks and dips.
Subwoofer test: punch custom 20–80Hz tones to rattle the sub — listen for port chuffing or bottoming-out distortion.
Frequently asked questions
Why can’t I hear the low or high frequencies?
Human hearing spans roughly 20Hz–20kHz, but most ordinary speakers and budget earbuds can’t produce below about 60Hz, and high-frequency perception falls with age — this is normal.
How do I test bass depth?
Type 40, then 30, then 20 into the custom frequency. The point where you stop hearing it is your depth; lower-and-still-audible means better low-bass control.
How do I test treble reach?
Try 14000 and 16000. Keep the volume low — high tones are hard on the ears. If you can’t hear them, your hearing or the device’s top end has rolled off.
A custom frequency plays no sound?
Make sure the value is within 20–20000Hz, the page isn’t muted, and the system volume isn’t zero.
Recommended test order
Keyboard & Mouse
Keyboards and mice are the input devices you use every day. Make sure to run the Keyboard Rollover Test, Keyboard Chatter Test, Mouse Double-click Test and Mouse Polling Rate Test — they catch key conflicts, double-typing and faulty switches while you can still return the device.
Screen & Refresh Rate
A newly bought monitor is a must-test — especially the Dead Pixel Test, Backlight Test, Grayscale Test and the Screen Refresh Rate Test. Phone screens are supported too — just remember to open the site in your phone browser for the Phone Screen Test.
Speakers, Microphone & Webcam
You are hereFor audio input and output, start with the Speaker Channel Test, Speaker Sweep Test, a quick Microphone Test and the Microphone Noise Test to confirm stereo balance, frequency response and a clean noise floor; the Webcam Test rounds it off with a check on image quality, smoothness and noise.
GPU & Gamepad
Need GPU muscle or big into gaming? Run the Volumeshader_bm GPU Test to stress your graphics card, then pick up the Gamepad Test and check the Controller Drift Test and Controller Rumble Test while you are at it.